Pitney-bowes DI600 Inserting System Manual de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 128
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
3 • Operator Functions
3-8 SV40221 Rev. C
SwiftStart™
SwiftStart™ allows you to load material into the feeders and run a
simple job with minimal setup information.
The job can then either be run without saving it to the machine’s
memory, or a Supervisor can name and save the Job Definition for
future recall as and when required.
TIP:
SwiftStart™ can be used as a way to quickly
programme a new Job Definition. Load material and run
SwiftStart™. A Supervisor can save the new job and
then use the Edit Job function (see page 4-4) to make
minor changes, if necessary.
Constraints and Requirements
Only use closed flap envelopes.
Feeds only single sheets from each Sheet Feeder.
This mode cannot be used to run fold only or inserts only.
You cannot link Sheet Feeders in this mode.
The Envelope Sealer is always on (except for the Trial
Piece).
The Batch Count is always off.
The Sheet Length must be 11-1/2” (292mm).
This mode will not work with OMR.
Loading Material for SwiftStart™
Loading Sheet Feeders
Depending on your envelope depth, the machine will automatically
select the fold type – Single or C (standard) fold.
For example, a standard sheet (8-1/2” x11”) inserted into a #10
envelope will receive a C fold, whereas a standard sheet inserted
into a 6” x 9” envelope will only receive a Single fold.
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 127 128

Comentarios a estos manuales

Sin comentarios