Pitney-bowes DI600 Inserting System Manual de usuario descargar pdf (Pagina 41)

Operator Functions • 3

3-11SV40221 Rev. C

Manual Feed

Manual Feed allows you to feed stapled or unstapled sets of up

to 5 sheets of 20 lb. (80g/m2) to a maximum total weight of

100 lb. (400g/m2). The sets are fed by hand, one set at a time, for

processing by the machine.

Using the Manual Feed automatically turns off all Sheet Feeders.

You can, however, use the Insert Feeder(s) if they have been

enabled by a Supervisor using the Manual Feed Setup explained on

page 4-8.

Constraints and Requirements

• Only use closed flap envelopes.

• This mode cannot be used to run fold only or inserts only.

• Sheet Feeders do not operate in this mode.

• The Batch Count is always off.

• Sets should contain sheets of the same length.

• This mode will not work with OMR.

Loading Material for Manual Feed Mode

Loading Insert Feeder(s)

Insert Feeder(s) will only operate if they have been enabled by a

Supervisor using the Manual Feed Setup explained on page 4-8 of

this guide.

For a single Insert, load Insert Feeder F. For two Inserts, load Insert

Feeders F and G.

Booklets must be loaded into Insert Feeder F only and should be

loaded with the bound edge first.

Pre-folded Inserts should be fed with the open edge last.

Reply Envelopes (BRE’s) must be loaded flap side down, flap first.

Loading Envelope Feeder

Envelopes are loaded into Envelope Feeder E flap side up, flap last.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 127 128

Sin comentarios

Pitney-bowes DI600 Inserting System Manual de usuario Pagina 41