Pitney-bowes Mailstation2 (K7M0) Manual de usuario

Install GuideUS English VersionDigital Postage Meter

6Special Network SettingsThis section is needed only if your network requires special settings to operate properly, such as static IPs and proxy serve

7 Installation Part 2 - Set Up Meter9Wireless Connection (Optional)To set up wireless capability, go to:www.pb.com/support/LANScroll down to selec

8 Installation Part 2 - Set Up Meter11 Install Ink CartridgeA1. Press the Enter key on the control panel.2. Lift the cover.NOTE: If the

9 Installation Part 2 - Set Up Meter11 Install Ink Cartridge (continued)Remove new cartridge from plastic bag.BRemove silver foil strip fr

10 Installation Part 2 - Set Up Meter12 Create a Test PrintWhen prompted, insert a spare envelope or a tape sheet for a test print.

11 Installation Part 2 - Set Up Meter13 Checking Your Account Balance and Adding Postage to Your System When your meter has succe

121415 Updating Your Software Congratulations! Your meter is operationalAfter loading postage into your system, the meter will automat

13Contact ListIf You Need Assistance• Product Name: mailstation™ or mailstation 2™ or Communication Device

15Connect the phone cord to the meter and the other end to an analog phone line.The following are usually analog lines:• Fax lines• Lines used by mode

Power Cordmailstation 2 Ink CartridgeReorder #797-MSample Pack ofTape SheetsReorder #612-9USB CablePhone CordInstall Guidemailstation Ink CartridgeReo

16 Alternative Method: Using Analog Phone Line2Install scalePosition the scale on top of the meter as shown. Connect the scale cable to the scal

17 Alternative Method: Using Analog Phone Line3Connect Power (continued)4Install Ink CartridgeA1. Press the Enter key on the control panel.2. Li

18 Alternative Method: Using Analog Phone LineRemove new cartridge from plastic bag.BRemove silver foil strip from bottom of ink cartridge.CDInst

19 Alternative Method: Using Analog Phone Line5Create a Test PrintWhen prompted, insert a spare envelope or a tape sheet for a test print.

20 Alternative Method: Using Analog Phone Line5Create a Test PrintGood test print - no missing inside linesNOTE: The test print will appear i

21 Alternative Method: Using Analog Phone Line7Checking Your Account Balance and Adding Postage to Your SystemWhen your meter has successfully c

22 Alternative Method: Using Analog Phone Line9Congratulations! Your meter is OperationalYour system is now ready to use. Also use the Quick Refe

23 Alternative Method: Using Analog Phone LineTroubleshootingNo Dial Tone - Check that you are using an analog line such as a) most fax machi

24If You Need Assistance• Product Name: mailstation™ or mailstation 2™

25

If network access is available for your meter, you can: If you do not have network access for your meter, go to page 15 “Altern

26

1 Elmcroft RoadStamford, Connecticut 06926-0700www.pitneybowes.comFor Service or SuppliesSupport Web Site: http://support.pb.com/K700

1 Installation Part 1 - Set Up Communication Device1Preparing for InstallationTo install your meter using the Internet, you will need the followin

2 Installation Part 1 - Set Up Communication Device23Locate the Communication Device and Network Cable ( )Connect the Communication Device to y

3Troubleshooting 1Communication Device may not be communicating to an active network port.Try the following:• Be sure the Network Cable ( ) is pr

4 Installation Part 1 - Set Up Communication DeviceWhen power is applied, the meter will display its startup screens and you will hear the meter

Installation Part 1 - Set Up Communication Device8Conrm ConnectionDO NOT press Enter on the meter yet.For wireless connection and meter setup go