Pitney-bowes DI425 FastPac Inserting Systems Manual de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
Operation • 2
2-7SV61656 Rev. A
3. Set the blue lever to the
number required.
4. Set the separator shield to
the letter required.
5. Fan the inserts and place
them onto the feed deck.
Loading orientation can vary
depending on the actual
inserts you’re running. For
many applications we sug-
gest the following:
Slip — Face up, bottom edge first
Reply Envelope — Face up, top edge first
Pre-Folded — Face up, closed edge first
Booklet — Face up,
bound edge first
Let the wedge slide down
behind the stack so that the
inserts are supported.
2. Refer to the label located on the insert feeder. Compare your
insert with the diagram. Read off the settings for the insert feeder
blue lever (numbers 1 to 9) and the separator shield (letters A to
D).
Thin Material
Thicker Material
Thick Inserts,
Booklets, etc.
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

Comentarios a estos manuales

Sin comentarios