Pitney-bowes DI425 FastPac Inserting Systems Manual de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
2 • Operation
2-10 SV61656 Rev. A
Choosing the New Job Number
The machine asks for the job
number you wish the new settings
to be stored under.
Use the Change (+/-) buttons to
display the job number you want.
Notes:
If you use an existing job
number, the old settings will be overwritten by the new settings
you are about to make.
If you want to find a currently unused job number, press Change
(+/-) until you see a job where the display shows no symbols
alongside the feeders or in the fold setup area. This means the
job number is currently unused.
Press Next (►) to advance to the next setting…
OMR
On models equipped with OMR ONLY, the machine will ask you to
select the OMR mode. For a non-OMR job, use Change (+/-) to se-
lect OMR off (if you wish to program an OMR job, see page 3-10).
Press Next (►) to advance to the next setting…
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 99 100

Comentarios a estos manuales

Sin comentarios